Simon G0FCU
g0fcu.bsky.social
Simon G0FCU
@g0fcu.bsky.social
330 followers 210 following 380 posts
Radio amateur callsign G0FCU. Mostly, but not exclusively, amateur radio content
Posts Media Videos Starter Packs
Very odd. I may put up something different. Need to have a think.
Today, I planned to remove my doublet and give it an overhaul. I found that the cord I use to haul the centre up to the chimney was badly worn so I can't use that again. The unused TV and FM radio antennas are both broken so may get an aerial guy to go up and sort it all out.
Are they still suffering from poor rx sensitivity?
9L8MD was much easier to work on 12m
Worked 9U1RU, received -05, sent -26, which is odd because all the other streams from them in the same period were -5/-6/-7
I'll give them a go in a bit, when I give up on 9U1RU again
Well done, I shall persevere
Just looking at map and I agree that makes sense
Burundi would be a new one for me. Why is XE seemingly so rare I wonder
It's a bad direction for me.
I'll carrying on trying for a while
They are but have you worked them? I haven't (yet)
Presumably because you will now only be allowed to hold one call (excluding special 3 character contest calls). No longer able to hold foundation, intermediate and full at the same time.
I saw you Phil, I was happy to work E6 and 3D2 for new slots on 10m. The /JD1 on 15m cw I didn't manage to work.
Just worked 5K0UA on 18090 FT8 for an ATNO
I now have 5 contacts on 15m 😀
Their policy is that they don't care about dups so I'd just go for it
The log shows 3 contacts on Fri for me on 15m but I made one on normal mode and one on SF so I can't help I'm afraid.
I worked E6AD twice this morning on 15m FT8, before breakfast on normal mode and after breakfast on superfox just for the hell of it. Around 9am but they didn't seem to stay on SF mode for long, they were a good signal.
I got my new rotator installed today but it wasn't a quick job. I also installed a new 1:1 balun for my 40/30m nested inverted-V.
Hope it will be less windy tomorrow.
Well done Phil. I bought a new rotator so hope to get that installed tomorrow then get back on the air.
I've looked at the ERC previously. I wonder if the bizarre behaviour of my controller will cause a problem.
I've only got a dipole on 17m but putting the mast up would have helped