Since I swiched to Eddy NG (with tap) Its also my minimum standard 🙂

There is so much gret work produced bye each team members in our team so I dont have words to describe it, I'm just flabbergasted about how good and fun this is. Thanks everyone 🙏

Thanks, it's a big honor being able to be part of the Arm team, this is just a smal piece of all the great work the whole team is contributing to ExecuTorch, working with this team and the tight collaboration with Meta and the community is one of the most exciting thing I have done in my life.

If we start calling them dartridges so we can keep the acronym, I don't see a big problem.

Wow, Thanks for all the work

I probably need to try and more with assemblies, I currenelty just add more and more parts to the same "sheet" :) It's getting more and more "hevy" to work with.

I wonder if the ML-model would work on somerhing Ethos-U55 based with 2Mb mem then it could even run on the Himax boards out there.

Yeah I got one out full size and for the other halv I reCADed it so I could print it in two halves 😊

This will save so much time, a perfect present for young people moving for the first time.

Thanks for this lists 🙏

Exactly this soup on youtube dot com is also one of my top 3, I have not put my top 3 soups in rate order yet but if I did it would definitely be one of my top two.

I have also seen those math rumors going around. I have been programming since around 1986 and have almost only used add, sub, mul and div. Maybe an occasional mod/rest, and some bit ops like and, or and not. Thats it!

Living in Lund I now must visit the place. Thanks for the tip.

This will turn out so much better than building with premade sheets as I originally planned. I think getting everything fasten good and resonable waterproof would be hard. Now I can adjust angels and add fastener on the inside and have small overlaps for water/weather in my prints from start.