Got a .4mm hardened steel nozzle from Anycubic directly, didn't think it would mean I had to recalibrate and tune all my settings, prints were coming out like crap, thought it was moisture. Speed down to 50, flow all the way down to 6, and temp up to 260, Kobra S1, elegoo Clear PETG...back to brass

Pro tip to anyone working on unit layouts ( arch) : block in the minimum required spaces before drafting. Don't waste time finishing a layout to only realize it does not work because the unit bathroom cannot fit or the bedroom is too small. Bathrooms, doors, min. clearances 1st.

Recently changed to a hardened steel nozzle, is my issue just my filament is too wet? This is with PETG. I tried drying but maybe not long enough/ hot enough. Using Kobra S1

First Frosty night of the year for me, I brought all my plants inside! Not something I considered when growing my plant collection! 😅

Finally got my official anycubic hardened steel nozzle, took almost 2 months to ship! The installation was a lot easier than I thought, if not almost painless. Still concerned the nozzle will scratch the bed, can only wait to see how the full calibration goes 🤞. Dreading changing the extruder...

Some tiny leaves sprouted at the base of my Hoya shepherdii, #hoyas Can someone tell if these are sprouts of my Hoya or just weeds? #indoorplants

Never seen a "sweet notice" before...wonder what that is a mistranslation of🤔

Pro #revit tip: if you are working on a model that is going or has gone through many back and forth changes - keep a model log. Know which version is what, mention any models reverted, file locations. Its painful to get back to a project years later only to find a mess w/o any notes.

Revit is down, due to AWS, Autodesk needs to change their status to outage, 150 products down is not a disruption. Time to do some offline tasks...
Health.autodesk.com

Autodesk health check site is down, and the ACC is throwing XML errors, not looking like a good day. Sync your models frequently #revit

Just got my first burn with. My 3d printer, I am officially initiated into the community.
On a side note what a pain in the ass it was to clear a clog in the extruder in the Kobra S1! That has totally turned me off the S1. I still like it, but brutal maintenance. Wonder if it's always like that...

Just installed Revit 2026 and was getting awful performance. Looks like hardware acceleration being on in the settings by default was the culprit, but now I can't use the new "accelerated graphics" feature...might be time to upgrade my PC 😞