kimmoli
@kimmoli.fi
blurry photo of 15m more drain piping
November 1, 2025 at 1:39 PM
blurry photo of 15m more drain piping
And when you try to ask TÄ, it fails on you
October 26, 2025 at 4:52 AM
And when you try to ask TÄ, it fails on you
Anyone can cross TX and RX... But be a hero and cross 1-wire
October 22, 2025 at 2:48 PM
Anyone can cross TX and RX... But be a hero and cross 1-wire
cross-heating with pump and stove.
October 18, 2025 at 2:26 PM
cross-heating with pump and stove.
Had my first MRI today. Why the bed is so unconfortable? Headrest is too low compared to the body. No problem with noises or claustrophobia, just unconfrotable for my neck, causing my right arm to go numb...
October 11, 2025 at 7:29 AM
Had my first MRI today. Why the bed is so unconfortable? Headrest is too low compared to the body. No problem with noises or claustrophobia, just unconfrotable for my neck, causing my right arm to go numb...
When run out of IO pins, use two as I2C and add expander to get one more...
October 5, 2025 at 4:50 PM
When run out of IO pins, use two as I2C and add expander to get one more...
long time since printing. choke lever for small atv, and end caps for brakepipe during installation
October 4, 2025 at 8:20 AM
long time since printing. choke lever for small atv, and end caps for brakepipe during installation
crap. my panasonic heat pump did go F11 (4-way valve abnormality)
Diag chart has error.... maybe? Coil resistance is 18 ohms, and it works, but controller output is ~3.5V...
I can switch the valve to heating by directly supplying it with 12V, so i have workaround until i get spare board.
Diag chart has error.... maybe? Coil resistance is 18 ohms, and it works, but controller output is ~3.5V...
I can switch the valve to heating by directly supplying it with 12V, so i have workaround until i get spare board.
September 27, 2025 at 2:46 PM
crap. my panasonic heat pump did go F11 (4-way valve abnormality)
Diag chart has error.... maybe? Coil resistance is 18 ohms, and it works, but controller output is ~3.5V...
I can switch the valve to heating by directly supplying it with 12V, so i have workaround until i get spare board.
Diag chart has error.... maybe? Coil resistance is 18 ohms, and it works, but controller output is ~3.5V...
I can switch the valve to heating by directly supplying it with 12V, so i have workaround until i get spare board.
wohoo, it did fit in my carage
September 21, 2025 at 7:17 AM
wohoo, it did fit in my carage
