Gordon Breuer
LightNews LightNews
banner
anheledir.bsky.social
Gordon Breuer
@anheledir.bsky.social
50 followers 79 following 4.3K posts
I'm a passionate .NET developer & IT Architect, working as Lead Software Engineer. Hobbies: 3D printing, 📷, Bunnies, StarCraft & Zootopia
Posts Replies Media Videos
Reposted by Gordon Breuer
esqueer.net
Here is the response from Harvard's legal counsel to the Trump Administration.
A formal letter dated April 14, 2025, from law firms Quinn Emanuel Urquhart & Sullivan and King & Spalding, addressed to officials at the General Services Administration, Department of Health & Human Services, and Department of Education. The letter, written on behalf of Harvard University, responds to a government letter dated April 11, 2025. It emphasizes Harvard's commitment to combating antisemitism and outlines recent measures the university has taken, including policy reforms, disciplinary procedures, and enhanced diversity efforts. The letter criticizes the government’s demands as unconstitutional, infringing on academic freedom and the First Amendment. Continuation of Harvard’s legal response, asserting that the federal government’s proposed terms exceed its lawful authority and violate university rights recognized by the Supreme Court. The letter argues that the demands would impose disruptive, unproven remedies and jeopardize critical federal research funding. It also stresses that the government’s terms would affect not just Harvard but also its affiliated medical and research institutions. Signed by attorneys William A. Burck and Robert K. Hur, the letter concludes that Harvard will not accept the government's terms as an agreement in principle but remains open to dialogue that respects legal boundaries.
April 14, 2025 at 5:42 PM
anheledir.bsky.social
March 22, 2025 at 1:54 AM
Reposted by Gordon Breuer
tonakuma.bsky.social
Stream END!

Sent the herd to graze with @BerryMontBlanc_ cause she was drawing sanic!

Thank you to the raiders, subbers and everyone!

Next stream is with @elitekatt.bsky.social this Friday 7PM PST for some #FFXIV
Screenshot from twitch of a raid Screenshot of two characters from Final Fantasy 14 Online
September 12, 2024 at 5:53 AM
anheledir.bsky.social
Sadly I’m full of ideas, but can’t really design with CAD 😅
February 24, 2025 at 11:00 PM
anheledir.bsky.social
I think some kind of inline-buffer attached right under each connector of the RepBox would be perfect. Maybe even with a little latch that pushes the filament directly into the other tube, and that can be loosened while printing to make room for the filament loop. 🤔
February 24, 2025 at 10:55 PM