Do make sure you are using the `refresh` branch. I needed to consolidate this project into a single branch, but haven't gotten to removing the other branches yet.
Do make sure you are using the `refresh` branch. I needed to consolidate this project into a single branch, but haven't gotten to removing the other branches yet.
1. Scan the environment
2. If an ore is detected, mine to it then scan again and repeat until no ores are detected (then move on to 4)
3. If no ore is detected, move on to 5
4. Return to the last y position (at the center of the shaft)
5. Dig down, move down, goto 1
1. Scan the environment
2. If an ore is detected, mine to it then scan again and repeat until no ores are detected (then move on to 4)
3. If no ore is detected, move on to 5
4. Return to the last y position (at the center of the shaft)
5. Dig down, move down, goto 1