ImpactFrame
banner
impactframe.bsky.social
ImpactFrame
@impactframe.bsky.social
Alex | 28 | He/Him
2D Character Artist/Animator
Animations, TTRPG stuff, and fanart of whatever's holding my interest.
Open to work
Commissions OPEN - Current Queue: 3
[email protected]
impactframe.carrd.co
Honestly kind of shocked me, given the company's history of complying in advance on LGBT stuff. I don't like a lot of the decisions the company makes, but I'll give them this one. It's better behavior than I expected.
January 10, 2026 at 5:47 PM
For real, learning firsthand why they've got that reputation.

I think I've seen a couple videos clowning on ML a good while back, but I'd forgotten about them when swinging by Target earlier. Was just thinking "Hm, picks are delivering today. I should grab a lock to try them out and practice."
January 5, 2026 at 8:07 PM
Also, when I do finally get the lock to engage properly to the point where I can use the pick, I literally just have to push up the first pin and it opens right away.

Maybe I just got a bad pull on the padlock gacha, but I don't think this specific one is going to be all that useful for practice.
January 5, 2026 at 6:38 PM
Like, I'm super not an expert. I've had the picks for like 10 minutes now.

To my knowledge, you're supposed to apply pressure with the tension wrench and use the pick to set the pins in place until the lock turns.

80 to 90% of the time, this lock just opens without even needing to use the pick.
January 5, 2026 at 6:11 PM
Oh, 100% agree. I am fully expecting this to be detrimental to my health, but some bits demand commitment.
December 30, 2025 at 7:09 PM
Actually remembered to record a timelapse for once.

Song:
TYRANTS BETTER RUN by LAKE SAVAGE
I Am Your Beast OST
December 27, 2025 at 3:12 AM
A closer look at the new sticker design, as well as a little more context to the decision:

Link to the new Sticker:
ko-fi.com/s/058af77ed7
December 2, 2025 at 11:07 PM
December 1, 2025 at 7:20 AM
December 1, 2025 at 7:20 AM
December 1, 2025 at 7:19 AM
Locking this again in like half an hour, then I'll see what I can get done on the plane.
December 1, 2025 at 1:53 AM
November 25, 2025 at 4:51 PM