@m0d0nne11.bsky.social
#snl50 is approx 24 minutes in and, so far, just barely funnier than the fart jokes heard from the average 11yr old. In other words, about as funny as it's been for the last 30+ years.... :(
February 17, 2025 at 1:29 AM
#snl50 is approx 24 minutes in and, so far, just barely funnier than the fart jokes heard from the average 11yr old. In other words, about as funny as it's been for the last 30+ years.... :(
Reposted
I'm afflicted with what might be described as "tabular incontinence" as I usually have dozens or hundreds of tabs open at once in my WWW browser (Firefox, of course) on my ancient laptop (circa 2016 but still going strong because I run Linux, of course) and it's normally fine...
February 14, 2025 at 12:13 PM
I'm afflicted with what might be described as "tabular incontinence" as I usually have dozens or hundreds of tabs open at once in my WWW browser (Firefox, of course) on my ancient laptop (circa 2016 but still going strong because I run Linux, of course) and it's normally fine...
Children are being physically altered at school - their actual flesh of their bodies permanantly modified, without parental permission!!! - by unqualified individuals acting on beliefs so misguided that they qualify as deranged. The alterations in question are easily visible and irreparable.
February 9, 2025 at 7:23 PM
Children are being physically altered at school - their actual flesh of their bodies permanantly modified, without parental permission!!! - by unqualified individuals acting on beliefs so misguided that they qualify as deranged. The alterations in question are easily visible and irreparable.
Our Robot Overlords are, in many ways, already here but I'm not sure ChatGPT is up to the task. Good grief! I only wanted to obtain an optimized cut-list to utilize some of the stock lengths of lumber available to yield a half dozen shorter pieces with minimal waste and I think I fried its brain.
January 23, 2025 at 10:39 PM
Our Robot Overlords are, in many ways, already here but I'm not sure ChatGPT is up to the task. Good grief! I only wanted to obtain an optimized cut-list to utilize some of the stock lengths of lumber available to yield a half dozen shorter pieces with minimal waste and I think I fried its brain.