Need to set some goals to keep this project moving. Fin fillets, and therefore essentially booster, are done!

First launch opportunity is just about a month away. Still need to:
- finish fwd payload & nosecone section
- determine parachute config
- run sims & buy motor
- paint!

Booster section of the LOC IV is getting there! Finished the fin & motor mount assembly and integrated it into the airframe. Still needs lots of epoxy and fin fillets to make it super strong. We’re going for structural integrity over anything else on this build.

Not sure how much I’ll use this because accounts can’t be private, but for now I’ll toss some photos from my L1 build.

Rings are fully installed onto the motor mount and will be installing fins soon using a custom 3D fin jig to help with alignment.

Hello World;