Peter Pak
LightNews LightNews
banner
ppak.net
Peter Pak
@ppak.net
6 followers 6 following 110 posts
I like building stuff
Posts Replies Media Videos
ppak.net
January 9, 2026 at 2:50 AM
ppak.net
Finished Trophy
January 9, 2026 at 2:50 AM
ppak.net
Post processed parts and initial assembly
January 9, 2026 at 2:50 AM
ppak.net
Print successful and deporting using SLS4All’s Easy Post Processing station
January 9, 2026 at 2:50 AM
ppak.net
Layer 141, 142, 143, and 144
January 9, 2026 at 2:45 AM
ppak.net
Layer 7, 8, and 9
January 9, 2026 at 2:40 AM
ppak.net
Around 230ish layers
January 9, 2026 at 2:37 AM
ppak.net
Going to print out the brackets and print bed with SLS. First print where I'm gonna pack the build chamber with parts.
January 9, 2026 at 2:35 AM
ppak.net
Finished trophies!
January 5, 2026 at 10:55 PM
ppak.net
Finished run, though engraving tool was a bit too deep
January 5, 2026 at 10:55 PM
ppak.net
Facing op
January 5, 2026 at 10:55 PM
ppak.net
Also change the 3/8” tool from high speed steel to my own carbide tool
3/8” High speed steel (left) carbide (right)
January 5, 2026 at 10:55 PM
ppak.net
Trying contour ops again now with just taking off 0.025”
January 5, 2026 at 10:55 PM
ppak.net
Seems that towards the end of the contour ops the screws holding the part in place broke.
Broken screws on workpiece
January 5, 2026 at 10:55 PM
ppak.net
Contours seems to be going well
January 5, 2026 at 10:55 PM
ppak.net
Also used 3/4” 6-32 screws with some nuts and washer to hold in the part better. Previously was using 1/2” and those didn’t seem to hold the stock to the fixture well enough
3/4” 6-32 screws on fixture plate with some nuts and washers for offset
January 5, 2026 at 10:55 PM
ppak.net
This is probably due to the fact that I forgot about the x and y offsets from the origin when making the mastercam file
Mastercam shows 0.125” offset from the x and y axis
January 5, 2026 at 10:55 PM
ppak.net
Contour op took a big chunk out before knocking the stock off the fixture plate.
Large notch where the tool ran into the stock before knocking it off the fixture plate
January 5, 2026 at 10:55 PM
ppak.net
Installation
December 23, 2025 at 12:06 AM
ppak.net
December 19, 2025 at 3:06 AM
ppak.net
Final result
December 13, 2025 at 3:34 AM
ppak.net
Yield rate of 1 out of 4
December 13, 2025 at 3:34 AM